If your phone has been flooded, the best way to repair it is not to use it for at least 24 hours. If you do, you may notice some problems using it. Water damage is more serious than you think. However, if your phone still works after 24 hours, you should try to get it to a repair shop immediately like visiting cell water damage Odessa TX. If not, you may have to pay to replace the phone.
Isopropyl alcohol
Isopropyl alcohol can be used to clean a cell phone with water damage. This substance can be found in chemists and is also widely available on Amazon. Avoid using it near naked flames and completely dry your phone afterward. The simplest way to fix a cell phone with water damage is to submerge it in a container filled with alcohol for about 15 minutes. Then, you can gently shake the cell phone under the alcohol to rinse off any contaminants.
The next step in fixing a water-damaged cell phone is to remove the plastic case and logic board. Once removed, use a soft brush to remove visible residue and clean the contacts and chips on the board. Remember to air dry the logic board before reassembling the phone. Doing so will risk causing additional damage when you turn it on. If you’ve managed to clean the logic board, you can proceed to clean the LCD screen. However, do not submerge the LCD screen because this may cause damage to the display.
Rice
If you find yourself with a water-damaged cell phone, one of the common remedies is to put it in rice. Although this sounds like a modern-day myth created by Internet hooligans with too much time on their hands, there are actually a few scientific reasons why this solution works. Professor Bruce Eisenstein, an electrical engineering professor at Drexel University, has studied this method.
The first step in fixing a water-damaged phone is to remove the battery. Next, put the phone in a shallow container with a lid and place it under bright light. The rice will absorb the moisture from the phone. The heat from the sun will accelerate this process. However, you should avoid doing this method if the phone has been exposed to water for a long period.
Drying
The first thing you should do after you find a wet cell phone is to dry it. The phone should not be turned on immediately and off to prevent electrical short circuits. Then remove the battery and the SIM or microSD card and gently wipe the inside of the phone. Next, you should dry the phone by placing it in a cool and dry place for several days. Then, you can put the phone back together and turn it on again.
If your phone is newer, it may be possible to shake the water off yourself. Using a hair dryer will blow the water away, but don’t let it sit in direct sunlight as this could corrode internal components. If the phone has not been completely soaked, you should submerge it in a dry bag or desiccant to induce dryness. However, make sure not to bury the phone in a bag of uncooked rice. Uncooked rice can introduce a lot of dust and starch, so keep the phone away from direct sunlight.
Desiccant
This is an effective way to dry out a wet phone, but it doesn’t remove the water entirely. It may sound like an easy fix, but it can hurt your electronics. Putting your phone in a bowl of rice to dry it out is not recommended, as the grain will get wedged into ports and expand when wet. In addition, using rice as a desiccant could damage your phone and ruin its functionality.
If you don’t have a desiccant, you can try blowing out the moisture using a mechanical air compressor set to a low setting. Be sure to blow across the surface and ports, as higher psi may damage internal components. After you’ve tried the above methods, you can place a desiccant inside your cell phone and plug it into an outlet.
